Sliding Door Lower Hinge

Sliding Door Lower Hinge:

REMOVAL
1. Remove sliding door trim panel.
2. Remove sliding door lower hinge cover.
3. Remove sliding door sill plate.
4. Remove lower track over travel stop.
5. Mark hinge location on sliding door for reference points when installing.
6. Support sliding door on a suitable lifting device. Do not allow door to contact quarter panel.
7. Remove bolts holding hinge to mounting bracket. If mounting bracket must be replaced, remove bolts holding mounting bracket to sliding door.
8. Separate hinge from sliding door.
9. Slide hinge from open end of track at rear of door opening.

INSTALLATION
Reverse the preceding operation. Align sliding door to 6 mm (0.240 in.) gap to edge of quarter panel and B-pillar, 7 mm (0.280 in.) gap to rocker and flush across gaps.