Front

1. Raise and support vehicle, then remove ten cradle plate mounting bolts and cradle plate.
2. Remove stabilizer link to stabilizer bar mounting nuts, then the stabilizer link.

Fig. 24 Stabilizer Bar Bushing Retainers:

3. Remove stabilizer bar bushing retainers from front suspension cradle.

4. Remove stabilizer bar and bushings as an assembly.
5. Reverse procedure to install, noting the following:

Fig. 25 Stabilizer Bar Bushing Installation:

a. Install bushings on stabilizer bar so that slit in bushing faces rear of vehicle and flat side faces ground when stabilizer bar is installed.

b. Position stabilizer bar so bushings are aligned with depression in cradle.

Fig. 26 Stabilizer Bar Bushing Retainer Installation:

c. Install bushing retainers so that raised bead is aligned with cutout on bushing.

Fig. 27 Stabilizer Bar Installation:

d. Center of stabilizer bar curved section must be aligned with raised line in center of front suspension cradle.