Installation

INSTALLATION

Hub/Bearing Removal And Installation:

1. Install the hub/bearing on the stub shaft of outer C/V joint and into the end of the axle.

Hub/Bearing Mounting Bolts:

2. In a progressive cries-cross pattern, tighten the 4 hub/bearing mounting bolts until the hub/ bearing is squarely seated against the axle. Then tighten the hub/bearing mounting bolts to a torque of 129 Nm (95 ft. lbs.).

Speed Sensor Attaching Bolt:

3. Install the wheel speed sensor on the hub/bearing and adapter. Install the wheel speed sensor attaching bolt. Tighten the wheel speed sensor attaching bolt to a torque of 12 Nm (105 inch lbs).
4. Install the rotor on the hub/bearing.

Removing/Installing Caliper:

5. Carefully lower caliper and brake shoes over rotor and onto the adapter using the reverse procedure for removal.

CAUTION: When installing guide pin bolts, extreme caution should be taken not to cross-thread the bolts.

Removing Caliper Guide Pin Bolts:

6. Install the caliper guide pin bolts. Tighten the guide pin bolts to a torque of 22 Nm (192 in. lbs.).

Hub Nut And Washer:

7. Clean all foreign material off the threads of the outer C/V joint stub shaft. Install the washer and hub nut on the stub shaft of the outer C/V joint.
8. Set the parking brake.
9. Tighten the hub nut to a torque of 244 Nm (180 ft. lbs.).

Spring Washer:

10. Install the spring washer on the stub shaft of the outer C/V joint.

Cotter Pin And Nut Retainer:

11. Install the nut retainer and cotter pin on the stub shaft of the outer C/V joint.
12. Install the wheel and tire assembly.
13. Tighten the wheel mounting stud nuts in proper sequence until all nuts are torqued to half specification. Then repeat the tightening sequence to the full specified torque of 115-156 Nm (84-115 ft. lbs.).
14. Remove jackstands or lower hoist.

CAUTION: Before moving vehicle, pump the brake pedal several times to ensure the vehicle has a firm brake pedal to adequately stop vehicle.