A. Replace Radiator Fan Relay

1. With the ignition key in the OFF position, disconnect the battery.

Note:
To enhance customer satisfaction, remember to reset the clock when you have completed the service procedure.

2. Remove the two (2) screws that attach the air inlet resonator to the upper radiator support.

3. Disconnect the upper and lower air inlet hoses from the resonator and remove the resonator.

4. Remove the air cleaner housing.





5. Locate the radiator cooling fan relay on the left front inner frame rail just behind the radiator (Figure 1).

6. Disconnect the radiator fan relay wiring connector.

7. Remove the radiator fan relay. Discard the relay and the attaching screws.

8. Install the new radiator fan relay using the supplied screws. Tighten the screws to 35 in-lbs (4 N.m).

CAUTION:
Do not over torque screws. To ensure heat transfer and proper operation, the new radiator fan relay must be installed using both of the provided screws.

9. Connect the radiator fan relay electrical connector. Slide the red latch to the locked position.

10. Install the air cleaner housing.

11. Install the resonator assembly and connect the upper and lower air inlet hoses.

12. Install the resonator to upper radiator support screws. Tighten the screws securely.

13. Connect the negative battery cable.