Power Window Switch: Service and Repair

Power Window Switch and Bezel Assembly Replacement

The Power Window Switch is integral to the bezel. If service to the switch is required, the complete bezel must be replaced. The Owe Door Lock Switch is serviced separately and must be transferred to the new bezel.

REMOVAL
1. Disconnect and isolate the battery negative cable.
2. Open door, remove screw cover near inside door release handle.
3. Remove two screws to Power Window Switch and Bezel Assembly. One under the screw cover removed in previous step and one to the rear of the front door vent opening.
4. Pull out and up on bezel to release from door trim panel.
5. Disconnect two switch connectors.
6. Remove two door lock switch retaining screws and remove switch from bezel.

INSTALLATION
For installation, reverse the above procedures.