Radio/Stereo: Service and Repair

REMOVAL
1. Disconnect and isolate the battery negative cable.
2. Remove cup holder.
3. Remove trim panel above cupholder by pulling straight out.
4. Remove center instrument panel trim panel.
5. Remove screws holding radio to instrument panel.

Fig.10 Radio:

6. Pull radio rearward to gain access to the back of radio.
7. Disconnect antenna cable from back of radio.
8. Remove bolt holding ground strap to the radio.
9. Disconnect the wire connectors from the back of the radio.

INSTALLATION
1. Connect wire harness to back of radio.
2. Install bolt holding ground strap to the radio.
3. Connect antenna cable to back of radio.
4. Position radio into instrument panel.
5. Install screws holding radio to instrument panel.
6. Install center instrument panel trim.
7. Install trim panel above cupholder.
8. Install cupholder.
9. Connect battery negative cable.