Wiring Harness Replacement

REMOVAL
1. Disconnect and isolate the negative battery cable.
2. Remove the appropriate door trim panel from the sliding side door. Refer to the Body for the procedure.

Fig.11 Lower Driver Cover:

3. Remove the lower drive unit cover retaining screws and remove the cover.
4. Disconnect the power side door electrical connector, located just behind the lower drive unit assembly.

Fig.16 Wire Harness Position & Orientation:

5. Disengage retaining pushpin and pull wire harness away from its power side door mounting location.
6. Using a flat bladed screwdriver, unsnap the wire harness retaining clip from the lower drive unit.
7. Slide the wire harness off the forward lower drive unit stud.
8. Using a pushpin removal tool, unsnap wire harness retaining pushpins from the rocker panel.
9. Remove side door lower sill plate. Refer to Body for the procedure.
10. Pull back the rearward edge of the B-pillar trim to access the wire harness connector and disconnect connector.
11. Remove the wire harness assembly from the vehicle.

INSTALLATION
1. Position the wire harness assembly in the vehicle.
2. Connect the wire harness connector located at the rearward edge of the B-pillar.
3. Install the side door lower sill plate. Refer to the Body for the procedure.
4. Snap the wire harness retaining pushpins in the rocker panel.
5. Slide the wire harness on the lower drive unit stud.
6. Install the wire harness retaining clip on the lower drive unit stud.
7. Connect the power side door electrical connector, located just behind the lower drive unit.
8. Install the lower drive unit cover and retaining screws.
9. Install the appropriate door trim panel on the sliding side door. Refer to the Body for the procedure.
10. Connect the negative battery cable.