Overhead Console Replacement

REMOVAL
1. Disconnect and isolate the negative battery cable.
2. Grasp the front of the overhead console and pull downward to disconnect the front retaining clips.
3. Slide the overhead console forward to disengage the rear tabs from the headliner.
4. Disconnect the overhead console wire connector.
5. Unsnap compass module from inner roof panel. Push module all the way forward to disengage the front retaining clip. Once the front clip is disconnected, push the module all the way rearward to disengage the rear retaining clip.
6. Remove console from vehicle.

INSTALLATION
1. Position overhead console into vehicle and snap compass module onto inner roof panel.
2. Connect overhead console wire harness connector.
3. Engage the rear tabs on the overhead console into the headliner.
4. Align the front retaining clips of the overhead console with the corresponding holes in the inner roof panel and firmly snap into place.
5. Connect the battery negative cable.
6. Calibrate compass (Refer to ELECTRICAL/OVERHEAD CONSOLE - STANDARD PROCEDURE).