Headlamp Leveling Switch - Export Test

1. Disconnect and isolate the battery negative cable.
2. Remove the center instrument panel bezel.
3. Remove the accessory switch bezel retaining screws and pull bezel away from instrument panel.
4. Disconnect the headlamp leveling switch electrical connector.

Fig. 23 Headlamp Leveling Switch:

5. Using an Ohmmeter and the HEADLAMP LEVELING SWITCH RESISTANCE table, check the resistance between switch connector pins 1 and 2.
6. If the test results are NOT as indicated in the HEADLAMP LEVELING SWITCH RESISTANCE table, replace the switch. If test results ARE as indicated in the HEADLAMP LEVELING SWITCH RESISTANCE table, the switch is OK at this time. (Refer to ELECTRICAL/LAMPS/LIGHTING - EXTERIOR/HEADLAMP LEVELING MOTOR - DIAGNOSIS AND TESTING) for further diagnosis.