NV T350 - Manual Transaxle

GEAR SHIFT MECHANISM / REMOVAL





1. Pull up on gearshift knob with moderate force to remove from gearshift mechanism (Fig. 128).





2. Remove shifter boot/bezel assembly from console by lifting up at mounting ring area (Fig. 129).





3. Remove the center console assembly as shown in (Fig. 130). Remove rear power window switch (if equipped) and disconnect harness from console.





4. Remove crossover cable retaining clip and disconnect from shift lever (Fig. 131).





5. Remove selector cable retaining clip and disconnect from shift lever (Fig. 132).





6. Remove four shifter assy.-to-floor pan nuts and remove shifter from vehicle (Fig. 133).

INSTALLATION
1. Install shifter assy. to floor pan (Fig. 133). Install and tighten four nuts to 12 Nm (105 in. lbs.) torque.
2. Install selector cable to shifter lever and secure cable to shifter bracket. Install clip (Fig. 132).
3. Install crossover cable to shifter lever and secure cable to shifter bracket. Install clip (Fig. 131).

NOTE: Only the crossover cable is adjustable. The selector cable does not have any adjustment capabilities.

4. Adjust crossover cable.
5. Install center console assembly (Fig. 130). Install rear power window switch (if equipped) and fasten harness to console.
6. Position gearshift boot (Fig. 129) over the gearshift mechanism and engage tab on mount ring at front to opening in console. Apply hand pressure to engage bosses on mount ring of boot to console opening slots.
7. Position gearshift knob hole over the gearshift mechanism (Fig. 128) and align the shift pattern.
8. Strike knob with rubber mallet to engage knob to mechanism.
9. Verify that shift pattern is aligned properly.