Passenger Seat Switch Test

1. Remove the power seat switch, refer to the Switch REMOVAL and INSTALLATION procedures in this section.
2. Using an ohmmeter, check pin # 1 of the power seat switch connector for continuity to ground. It should be present, If OK go to Step 3 , If NOT OK repair the open ground circuit as required.
3. Using an voltmeter, check pin # 5 of the power seat switch connector for approx. 12v. It should be present, If OK go to Step 4 , If NOT OK repair the open voltage supply circuit as required.

Passenger Seat Switch Continuity Test Table:

Fig.3 Seat Switch Pin Call-Out:

4. Using an ohmmeter, perform the Seat Switch Continuity Test table using. If there is no continuity at any of the switch positions, replace the power seat switch.