Rear

REMOVAL
1. Raise vehicle.
2. Remove the bolts securing the stabilizer bar to links on each side of bar.
3. While holding the stabilizer bar in place, remove the bolts that attach the stabilizer bar bushing retainers to the rear axle.
4. Remove the stabilizer bar from the vehicle.

INSTALLATION
1. Lift the stabilizer bar onto the rear axle and install the two retainer mounting bolts. DO NOT TIGHTEN.
2. Install the bolts attaching the stabilizer bar links to the stabilizer bar. DO NOT TIGHTEN.
3. Lower the vehicle so that the full weight of the vehicle is on all four tires. With the vehicle at its curb height, tighten the following bolts to the torques listed:
^ Stabilizer bar bushing retainer-to-axle bracket bolts - 61 Nm (45 ft. lbs.)
^ Stabilizer bar-to-link - 61 Nm (45 ft. lbs.)