Shroud - Upper

REMOVAL





1. Remove the two shroud-to-shroud mounting screws from the lower shroud.
2. Unsnap the upper shroud from the lower on the left side as follows:





a. Hook a finger on the left hand around the rear of the shrouds at the seam, near the snap points.
b. Grasp the upper shroud at the rear using the right hand.
c. As the left hand's hooked finger is pulled outward against the seam, pull the upper shroud upward using the right hand, disconnecting the shroud snaps.
3. Unsnap the upper shroud from the lower on the right side as follows:





a. Hook a finger on the right hand around the rear of the shrouds at the seam, near the snap points.
b. Grasp the upper shroud at the rear using the left hand.
c. As the right hand's hooked finger is pulled outward against the seam, pull the upper shroud upward using the left hand, disconnecting the shroud snaps.
4. Lift the upper shroud straight up off the steering column. If vehicle is equipped with traction control, disconnect wiring connector at traction control switch pig tail. If vehicle is equipped with power foldaway mirrors (Export), disconnect wiring connector at mirror switch pig tail. Remove upper shroud.
5. If vehicle is equipped with traction control, remove traction control switch from shroud.
6. If vehicle is equipped with power foldaway mirrors (Export), remove power fold-away switch from upper shroud.

INSTALLATION
1. If the vehicle is equipped with power foldaway mirrors (Export), install the power fold-away switch in the upper shroud.
2. If vehicle is equipped with traction control, install the traction control switch in the upper shroud.
3. Place the upper shroud over the lower shroud, aligning the snap clips and alignment tabs. If the vehicle is equipped with traction control, connect the wiring connector at the traction control switch pig tail before lining the shrouds up to one another.
4. Snap the upper shroud to the lower shroud. Once snapped into place, verify there are no gaps between the two mating surfaces of the shrouds.
5. Install the two shroud-to-shroud mounting screws. Tighten the screws to 2 Nm (17 in. lbs.) torque.
6. Ensure that the shrouds are snug and fit is acceptable.