F. PCM/Vehicle Data Set-Up

1. Connect the DRB III(R) to the data link connector located under the instrument panel. Turn the ignition key to the "ON" position.

2. With the ignition switch in the "ON" position, determine if the vehicle is equipped with a SKIM module by using the DRB III and selecting from the menu screen:

a. Select # 1 - "DRB III Standalone" from Main Menu screen.

b. Select # 1 - "1998 - 2004 Diagnostics" from Standalone Main Menu
screen.

c. Select # 1 - "All (Except Below)" from 1998 - 2004 Diagnostics screen.

d. Select # 8 - "System Monitor" from Select System screen.

e. Select # 3 - "J1850 Module Scan" from Select Monitor screen and then press ENTER to continue and note if the vehicle is equipped with SKIM.

> If the vehicle is equipped with SKIM obtain the vehicle PIN (Personal Identification Number) before continuing with Step 3. This information is available from the original selling invoice, the Dial VIP System, or by contacting the DaimlerChrysler Customer Assistance Center (DCCAC). WARNING: Failure to use the SKIM PIN number to transfer the secret key code data from the SKIM module will cause a no-start condition. If the vehicle is not equipped with SKIM then continue with Step 3.

f. Press PAGE BACK.

3. Press PAGE BACK to return to the Select System screen.

4. Select # 1 - "Engine" from Select System screen.

5. Press ENTER to continue.

6. Press the RIGHT ARROW key.

7. Select # 1 - "Miscellaneous".

8. Select # 3 - "Check VIN".

9. Press ENTER to program the VIN.

> If the vehicle is equipped with SKIM:

a. Press ENTER to continue.

b. Press ENTER to continue again.

c. Enter the vehicle 4-digit PIN.

d. Press ENTER to continue.

e. Press ENTER to continue again.

f. Press ENTER to continue again.

g. Press ENTER to update VIN.

h. Press ENTER to continue.

i. Press ENTER to transfer secret key data.

j. Press ENTER to continue.

k. Cycle ignition key to "OFF" position and then back to "ON" position and then press ENTER.

l. Press any key to continue.

> If the vehicle is NOT equipped with SKIM:

a. Enter the 17-digit VIN.

b. Press ENTER to continue.

c. Press PAGE BACK.

10. Select # 1 - "Miscellaneous".

11. Select # 1 - "Check PCM Odometer".

12. Press YES if the vehicle has LESS than 50 miles on the odometer or press NO if the vehicle has MORE than 50 miles on the odometer.

13. Enter current odometer reading and then press ENTER.

14. Cycle ignition key to "OFF" position and then back to "ON" position and then press ENTER.

15. Press PAGE BACK.

16. Press PAGE BACK again.

17. Select # 2 - "Transmission".

18. Select # 1 - "Transmission Module".

19. Select # 9 - "Miscellaneous".

20. Select # 3 - "Pinion Factor".

21. Press any key to continue.

22. Select the correct tire size for the vehicle and then press ENTER.

23. Verify the selected tire size and then press PAGE BACK to exit.

24. Select # 6 - "Quicklearn" and then follow the instructions displayed on the DRB III screen.

25. Disconnect the DRB III.