Gear Shift Lever
REMOVAL1. Remove the knee blocker.
2. Remove the knee blocker reinforcement.
3. Remove the upper and lower shrouds.
4. Remove the cluster trim bezel.
5. Remove the fixed shroud from the column.
6. Disconnect the electrical connector to the BTSI.
7. Remove the two screws securing the BTSI to the steering column.
8. Disconnect the SKIM electrical wire connector.
9. Remove the SKIM from the steering column.
10. Disconnect the auto stick wiring connector (if equipped with auto stick).
11. Disconnect the shifter cable at the shifter.
12. Remove the three screws securing the shifter to the steering column.
13. Remove the shift lever from the column.
INSTALLATION
1. Install the shifter cable to the shifter.
2. Install the three screws securing the shifter to the steering column.
3. Install the shifter cable at the handle.
4. Install the SKIM to the steering column.
5. Reconnect the SKIM electrical wire connector.
6. Reconnect the auto stick wiring connector (if equipped with auto stick).
7. Install the two screws securing the BTSI to the steering column.
8. Reconnect the electrical connector to the BTSI.
9. Install the fixed shroud to the column.
10. Install the cluster trim bezel.
11. Install the upper and lower shrouds.
12. Install the knee blocker reinforcement.
13. Install the knee blocker.