Operation CHARM: Car repair manuals for everyone.

Keyless Entry - Short Remote Transmitter Range

NUMBER: 08-023-04

GROUP: Electrical

DATE: June 15, 2004

THIS BULLETIN IS BEING PROVIDED IN ADVANCE. DO NOT ORDER PARTS OR PERFORM ANY ACTIONS RELATED TO THIS BULLETIN UNTIL JULY 1, 2004.

SUBJECT:
Improved Remote Keyless Entry Range

OVERVIEW:
This bulletin involves replacing the security alarm module and reprogramming all the key fobs.

MODELS:

2002 - 2003 (RG) Chrysler Voyager

NOTE:
This bulletin applies to right hand drive vehicles equipped with a Premium Security Alarm (sales code LSC).

SYMPTOM/CONDITION:

The vehicle operator may describe that the Remote Keyless Entry (RKE) fobs do not operate unless very close to the vehicle.

NOTE:
All of the customer's fobs are required for testing and repair.

DIAGNOSIS:

The technician should operate all of the customer's RKE fobs and determine the range of the RKE fobs. If the range of the any RKE fob is less than 3 meters (10 ft.), check the signal strength of the RKE fob using Miller special tool p/n 9001. If the signal strength is low, check and replace the battery if necessary. If the technician determines the fob's range is less than 3 meters (10 ft.), and the RKE fobs pass testing, perform the Repair Procedure.





PARTS REQUIRED:





SPECIAL TOOLS/EQUIPMENT REQUIRED:

REPAIR PROCEDURE:

1. Disconnect and isolate the battery negative cable.

2. Remove instrument panel top pad. Refer to the appropriate (2003 or 2004) Year End Final Technical Publications - Car CD. Refer to 23 - Body/Instrument Panel/Instrument Panel Top Pad - Removal.

3. Remove screws holding the security alarm module to instrument panel.





4. Disconnect the wire connectors and remove the security alarm module (Fig. 1).

5. Position the new security alarm module, p/n 05161581AA, install and tighten the fasteners.

6. Connect the wiring connectors.

7. Install the instrument panel top pad.

8. Connect the battery negative cable.

NOTE:
All of the customer's RKE fobs must be programmed in the next step.

9. Program the RKE fobs. Using the DRBIII(R) select:

a. "DRBIII Standalone"

b. "1998 - 2005 Diagnostics"

c. "All (except below)"

d. "Body Interior"

e. "Body Computer"

f. "Miscellaneous"

g. "Program RKE"

h. Follow the instructions on the DRBIII(R) screen.

POLICY:
Reimbursable within the provisions of the warranty.





TIME ALLOWANCE:





FAILURE CODE:

Disclaimer:
This bulletin is supplied as technical information only and is not an authorization for repair.