Right End Cap

REMOVAL
1. Remove glove box assembly:
2. Open glove box and push in on the sides of the glove box bin to allow the retainers to clear the instrument panel.
3. Let the glove box drop down to the floor.
4. Remove two screws to the right instrument panel end cap.
5. Pull end cap rearward to unsnap and remove from vehicle. Maneuver it out from underneath the right A-pillar trim and top cover. Removal of these components is not necessary.

INSTALLATION
1. Place the right end cap in position and snap into place. Make sure that it is underneath the A-pillar trim and top cover.
2. Install two screws to the right instrument panel end cap.
3. Lift glove box assembly up, push in on the box/ bin sides to allow the glove box retainers to pass by the instrument panel.
4. Close glove box door.