Quarter Glass - Convertible

QUARTER GLASS - CONVERTIBLE

REMOVAL




1. If possible, raise the quarter glass (1) to the full up position to aid in removal.
2. Remove the rear quarter trim panel. Refer to Trim Panel.
3. Remove the water dam from thinner quarter panel.
4. Lower the convertible top.
5. Disconnect the wire connector to the power window motor.
6. Remove the three nuts (4) that secure the quarter window module (3) to inner quarter panel.
7. Lift the quarter window module upward and out of the opening at the top of the quarter panel.
8. If required, remove the three screws (5) and nuts (2) that secure the quarter glass and bushings (6) and remove the quarter glass.

INSTALLATION




1. If required, position the quarter glass (1) and bushings (6) onto the quarter window module (3) and loosely install the three screws (5) and nuts (2) that secure quarter glass to the window module.
2. Install the quarter window module into position through the opening in the top of the quarter panel.
3. Install the three nuts (4) that secure the quarter window module to inner quarter panel. Tighten the nuts securely.
4. Connect the wire connector to the power window motor.
5. Raise the convertible top.
6. Adjust quarter glass as necessary and tighten the three screws and nuts that secure quarter glass to the window module.
7. Install the water dam onto the inner quarter panel. Make sure that enough adhesive remains to securely retain the water dam. Replace the water dam if required.
8. Install the rear quarter trim panel.