Convertible Top Switch: Service and Repair
REMOVAL1. Disconnect and isolate the battery negative cable.
2. Remove the instrument panel center bezel.
Accessory Switch Bezel:
3. Remove two screws retaining the accessory switch bezel.
Accessory Switch Bezel Connectors:
4. Disconnect the harness connectors to the following:
- Power Top Switch
- Rear Window Defogger Switch (if equipped)
- Traction Control Switch (if equipped)
- Cigar Lighter/Power Outlet
Accessory Switch Bezel Switch:
5. To remove the power top switch from the bezel, use both thumbs and slightly pull out on the two retaining tabs holding the switch.
INSTALLATION
Accessory Switch Bezel Switch:
1. From the rear of the switch bezel, gently push the power top switch in until it is secured by the two retaining tabs.
Accessory Switch Bezel Connectors:
2. Reconnect the accessory switch bezel connectors.
Accessory Switch Bezel:
3. Reinstall switch bezel into instrument panel opening and install two retaining screws.
4. Reinstall instrument panel center bezel.
5. Connect the battery negative cable.
6. Verify power top system operation.