Fluid Drain and Fill

STANDARD PROCEDURE - FLUID DRAIN AND FILL

NOTE: All T350 Manual Transaxles require the use of ATF+4 (Automatic Transmission Fluid).





The transaxle fill plug is located on the left side of the transaxle differential area (Fig. 96). The fluid level should be within 3/16 inch from the bottom of the transaxle fill hole (vehicle must be level when checking).





The transaxle drain plug is located on the lower right side of the transaxle differential housing (Fig. 97). Tighten drain plug to 14 Nm (120 inch lbs.).

Fill transaxle to capacity with suitable amount of ATF+4. Refer to chart. Wipe the outside of the transaxle if any lubricant spills.





NV T350 MANUAL TRANSAXLE FLUID FILL