Removal - PT-27

REMOVAL
1. Remove door trim panel and water dam.
2. Disconnect wire connector to power window motor.
3. Remove nuts attaching regulator lift channel to door glass.
4. Secure door glass in upward position.

Smart Module Regulator:

5. Remove nuts attaching rear of stabilizer channel to door panel.
6. Remove stabilizer channel from door panel.
7. Loosen bolts attaching window regulator, base plate to door inner panel.
8. Remove window regulator through large hole in inner door panel.
9. Remove power window motor from regulator.

INSTALLATION
1. Move window regulator into position in door and engage bolt heads into key hole slots in door inner panel.
2. Install stabilizer channel to door panel.
3. Install nuts to stabilizer channel.
4. Tighten rear and front nuts of roller channel.
5. Install bolts attaching window regulator base plate to door inner panel.
6. Tighten top forward bolt, bottom rearward bolt, top rearward and then bottom forward bolt attaching window regulator base plate.
7. Install nuts attaching regulator lift channel to door glass.
8. Connect wire connector to power window motor.
9. Verify glass fit and operation. Adjust door glass, if necessary.
10. Install door water dam and trim panel.