Liftgate Cylinder Lock Switch Replacement

REMOVAL
1. Open hood.

Fig.4 Battery Negative Cable Remove/Install:

2. Disconnect and isolate the battery negative cable.
3. Remove the liftgate trim panel.
4. Remove the liftgate cylinder U-bracket by sliding it out.
5. Remove switch E-clip and disconnect connector.

Fig. 8 Liftgate Cylinder Lock Switch Location:

6. Remove liftgate cylinder lock switch from liftgate lock cylinder by gently unsnapping.

INSTALLATION

Fig.5 Door Cylinder Lock Switch Remove/Install - Typical:

1. Install liftgate cylinder lock switch on rear of liftgate lock cylinder without rotating the switch.
2. Install the liftgate cylinder U-bracket by sliding it in.
3. Install switch E-clip and connector.
4. Install the liftgate trim panel.
5. Connect the battery negative cable.
6. Close hood
7. Verify vehicle and system operation.