Rear Seat Back Cover/Foam

REAR SEAT BACK COVER/FOAM

REMOVAL

COUPE




1. Remove seat from vehicle.




2. Remove head restraint.




3. Remove rear seat back.




4. Disengage the J-strap retainer.




5. Roll cover upward to hog rings (1). Cut hog rings to free cover.
6. Roll cover to top of seat back and remove head restraint sleeve guides.
7. Remove cover from seat back.

CONVERTIBLE




1. Remove seat from vehicle.
2. Remove rear seat back.




3. Disengage the J-strap retainer.




4. Roll flap back to access push pin fasteners (1).




5. Raise back flap to release the hook and loop (2) to access the J-strap (1) and hog rings (3). Release J-strap (1) and cut the hog rings (3).




6. Disconnect the lower J-strap from the rod.




7. Disconnect the upper J-strap from the rod.




8. Roll cover upward to hog rings (1). Cut hog rings to free cover.




9. Roll seat cover bottom to clear the foam.




10. Roll seat back cover to the hog rings. Cut hog rings (1).




11. Pull back panel (1) free of the seat cover and foam (2).




12. Remove seat back cover from the foam.

INSTALLATION

COUPE




1. Position cover at the top of seat back.




2. Carefully roll cover down to the area that hog rings are to be installed.
3. Install hog rings.
4. Roll cover downward.




5. Engage the J-strap retainer
6. Install new head restraint sleeve guides.
7. Install seat back to seat cushion. Tighten bolts to 40 N.m (30 ft. lbs.) torque.




8. Install seat in vehicle.




9. Install head restraint.
10. Check seat back and headrest operation.

CONVERTIBLE




1. Place seat back panel on to the foam. Roll seat cover onto the back panel (1) and foam (2).




2. Pull seat back cover down into position and install the hog rings (2).




3. Pull seat cover down and around the bottom of the seat back.




4. Roll cover upward to hog rings (1). Cut hog rings to free cover.




5. Connect the J-strap to the upper rod.




6. Connect the J-strap to the from lower rod.




7. Connect the J-strap (1) and install hog rings (3).




8. Install push pin fasteners (1). Pull seat back cover down and smooth out any wrinkles.




9. Engage the J-strap retainer (1).




10. Install rear seat back.
11. Install rear seat.