Left End Cap

REMOVAL
1. Remove the left lower instrument panel bezel. Pull top rearward, lower to floor and with a quick pulling motion remove off instrument panel.
2. Remove two screws to the left instrument panel end cap.

Left Instrument Panel End Cap - Typical RT & LT Side:

3. Pull the left end cap rearward to unsnap. Maneuver it out from underneath the left A-pillar trim and top cover. Removal of these components is not necessary.
4. Disconnect the power mirror switch wiring connector (if equipped) and remove from vehicle.

INSTALLATION
1. Connect the power mirror switch wiring connector (if equipped).
2. Place the left end cap in position and snap into place. Make sure that it is underneath the A-pillar trim and top cover.
3. Install two screws to the left instrument panel end cap.
4. Place left lower instrument panel bezel in position and make sure the orientation of the hinge is correct and snap bezel hinge into place.
5. Roll bezel upward and snap into place.