Headlamp: Service and Repair

REMOVAL
1. Raise vehicle on a hoist.
2. Remove wheel and tire.
3. Remove splash shield as necessary to access headlamp housing.
4. Remove grille.

Fascia Center Attaching Point:

Loosening The Fascia:

5. Remove the two fascia bolts from behind the grille.
6. Remove fasteners attaching fender to fascia on the side being worked on.
7. Remove the three fasteners holding the lower fascia to the lower radiator crossmember.

Head Lamp Unit Housing:

8. Remove four nuts attaching headlamp housing.

Head Lamp Unit Removal:

9. Remove headlamp housing by lowering the fascia as necessary.
10. Disconnect wire connector.

INSTALLATION

CAUTION: Do not touch the glass of halogen bulbs with fingers or other possibly oily surface, reduced bulb life will result.

1. Connect wire connectors to the back of headlamp housing.
2. Place headlamp housing in to position, lower fascia as necessary to install headlamp housing in to position. Tilt headlamp unit to opening as necessary.
3. Install nut(s) attaching headlamp housing.
4. Test lamp operation.
5. Install fasteners attaching fender to fascia on the side being work on.
6. Install the two fascia bolts from behind the grille.
7. Install three fasteners to hold the lower fascia to the lower radiator crossmember.
8. Install grille.
9. Install splash shield as necessary to access headlamp housing.
10. Install wheel and tire.
11. Lower vehicle.