Cruise Control Switch: Service and Repair

CRUISE CONTROL SWITCH

REMOVAL

Fig. 14 Speed Control Switch:

The speed control switch is mounted in the steering wheel and wired through the clockspring device under the airbag module.

WARNING: IF REMOVAL OF AIRBAG MODULE IS NECESSARY, REFER TO THE RESTRAINT SYSTEMS.

1. Remove the air cleaner lid, disconnect the inlet air temperature sensor and makeup air hose.
2. Remove the negative battery cable.
3. Turn off ignition.
4. Remove air bag, refer to the Restraint systems.

Fig. 15 Switch Top Mounting Screw:

5. Remove the top mounting screw.
6. Rotate steering wheel so that the switch is in the 6 o'clock position. Remove 2 screws from the back side of the speed control switch.
7. Disconnect the electrical connector.

Fig. 16 Switch Removal:

8. Remove switch.

INSTALLATION
1. Connect the electrical connector.
2. Install switch and tighten the screws to 1.6 Nm (15 in. lbs.). Make sure rubber seal is in place around switch.
3. Install airbag, refer to the Restraint Systems.
4. Install the negative battery cable.
5. Install the air cleaner lid connect the inlet air temperature sensor and makeup air hose