Combination Switch: Service and Repair

REMOVAL
1. Open hood.

Battery Negative Cable Remove/Install:

2. Disconnect and isolate the battery negative cable.
3. Remove both upper and lower steering column shrouds.

Multi-Function Switch Remove/Install:

4. Disconnect both posi-lock harness connectors at the rear of the multi-function switch
5. Remove multi-function switch mounting screws and remove switch from vehicle.

INSTALLATION

NOTE: If replacing the multi-function switch, the combination flasher and windshield wiper/washer switch must be transferred to new multi-function switch. Remove the two torx screws retaining the wiper/ washer switch, place next to the new multi-function switch and install two screws.

1. Place switch into place and install mounting screws. Torque multi-function switch to column retaining screws to 3 N.m (27 in.lbs.).
2. Connect both posi-lock harness connectors at the rear of the multi-function switch.
3. Install both upper and lower steering column shrouds.
4. Connect the battery negative cable.
5. Close hood.
6. Verify vehicle and system operation.