Thermal Guard

REMOVAL

WARNING: TO PROTECT THE HANDS FROM BATTERY ACID, A SUITABLE PAIR OF HEAVY DUTY RUBBER GLOVES, NOT THE HOUSEHOLD TYPE, SHOULD BE WORN WHEN REMOVING OR SERVICING A BATTERY. SAFETY GLASSES ALSO SHOULD BE WORN.

1. Make sure ignition switch is in OFF position and all accessories are OFF.
2. Open hood.
3. Remove air cleaner housing.
4. Disconnect and isolate the battery negative cable.
5. Disconnect the battery positive cable.
6. Loosen bolt and retainer that holds the battery down to the tray.
7. Lift battery out of battery tray and remove from vehicle.
8. Carefully lift the thermal guard off over the battery taking care not to tear it.
9. Remove the thermal guard from battery.

INSTALLATION
When replacing battery the thermal guard MUST be transferred to the new battery.
1. Slip the battery thermal guard over the battery being careful not to tear it.
2. Install battery in vehicle.
3. Install battery hold down clamp, making sure that it is properly positioned on battery.
4. Connect battery cable clamps to battery posts. Install battery positive cable first.
5. Tighten clamp nuts securely.
6. Install the air cleaner housing.