Controller Antilock Brake (MK20E)

REMOVAL
1. Disconnect the battery cables.
2. Remove the battery.
3. Disconnect the vacuum hose connector at the tank built into the battery tray.
4. Remove the screw securing the coolant filler neck to the battery tray.
5. Remove the battery tray.

CAB Connector Lock:

6. Pull up on the CAB connector lock and disconnect the 24-way electrical connector.
7. Disconnect the pump/motor connector from the CAB.

CAB Mounting Screws:

8. Remove the screws securing the CAB to the HCU.
9. Pull CAB straight forward off HCU.

INSTALLATION
1. Slide the CAB onto the HCU.
2. Install screws securing the CAB to the HCU. Tighten the mounting screws to 2 N.m (17 in lbs).
3. Reconnect the 24-way wiring connector and the pump/motor wiring connector.
4. Install the battery tray.
5. Install the screw securing the coolant filler neck to the battery tray.
6. Reconnect the vacuum hose to the coolant tank built into the battery tray.
7. Install the battery.
8. Reconnect the battery cables.
9. Connect a DRBIII(R) to the vehicle. Check and clear any faults, and initialize the system.