B222C
B222C-VEHICLE CONFIGURATION NOT PROGRAMMEDWHEN MONITORED
With the ignition on.
SET CONDITION
The Totally Integrated Power Module is not configured correctly to the vehicle.
POSSIBLE CAUSES
- Totally integrated power module not configured correctly
- Totally integrated power module
Diagnostic Test
1. CHECK FOR ACTIVE DTC
With the scan tool, read the active DTC's.
Cycle the ignition switch from off to on at least 5 times, leaving the ignition on for a minimum of 90 seconds per cycle.
With the scan tool, read the active DTC's.
Q: Does the scan tool display this DTC as active?
YES: Go To 2
NO: If the DTC is stored, check for an intermittent condition. Visually inspect the related wiring harness connectors. Look for broken, bent, pushed out, or corroded terminals.
2. CONFIGURE THE TIPM TO THE VEHICLE
With the scan tool enter program network configuration and program the TIPM to the vehicle configuration.
With the scan tool, erase TIPM DTC's.
Cycle the ignition switch from off to on at least 5 times, leaving the ignition on for a minimum of 90 seconds per cycle.
With the scan tool, read the active DTC's.
Q: Does the scan tool display this DTC as active?
YES: Inspect the wiring and connectors for damage or shorted circuits. If ok, replace and program the Totally Integrated Power Module. Perform the BODY VERIFICATION TEST - VER 1. Body Verification Test
NO: Repair is complete.