Powertrain Control Module

MODULE-POWERTRAIN CONTROL

REMOVAL




1. Disconnect the negative battery cable.
2. Remove plastic clips that hold the wiring harness to the support bracket.




3. Unlock and disconnect the 3 or 4 electrical connectors (1) from the Powertrain Control Module (PCM).




4. Remove the clutch reservoir and relocate.




5. Remove the four mounting bolts (1) from the PCM mounting bracket.




6. Remove PCM and mounting bracket.




7. Remove the three mounting bolts (2) from the PCM bracket to PCM.

INSTALLATION




1. Install the PCM bracket and three mounting bolts (2) to the PCM and tighten to 11.8 N.m (105 in. lbs.).




2. Tip PCM and bracket assembly into bracket.
3. Locate the PCM and bracket assembly bracket on the tab (2).







4. Install the four mounting bolts to the PCM mounting bracket (1) and tighten to 10.7 N.m (95 in. lbs.).




5. Relocate and install the clutch reservoir.

NOTE: The electrical connector for the PCM are COLOR Coded.




6. Connect and lock the 3 or 4 electrical connectors (1) to the Powertrain Control Module (PCM).
7. Install plastic clips that hold the wiring harness to the support bracket.
8. Connect the negative battery cable.