Backup Lamp Switch: Service and Repair

T350 MANUAL TRANSAXLE

BACK-UP LAMP SWITCH

REMOVAL
1. Lift vehicle on hoist.





2. From bottom side of vehicle, disconnect back-up lamp switch connector (1).
3. Unscrew switch (2) from transaxle.

INSTALLATION





Install back-up lamp switch (2). Teflon tape or equivalent must be used on switch threads. Tighten switch to 24 Nm (18 ft. lbs.) torque.

CAUTION: Do not overtighten switch.

1. Connect back-up lamp switch connector (1).
2. Lower vehicle.
3. Verify back-up lamp operation.