Left Multi-Function Switch
LEFT MULTI-FUNCTION SWITCHREMOVAL
NOTE: It is not necessary to remove the Steering Column Control Module (SCCM) from the steering column to replace the left multi-function switch.
1. Disconnect and isolate the battery negative cable.
WARNING: WAIT TWO MINUTES FOR THE SYSTEM RESERVE CAPACITOR TO DISCHARGE BEFORE SERVICING ANY AIRBAG OR STEERING COLUMN COMPONENTS.
2. Remove both the upper and lower shrouds from the steering column.
3. Remove the one screw (3) that secures the left multi-function switch (2) on the right side of the SCCM (1).
4. Pull the switch (2) straight away from the SCCM (1) far enough to access the electrical connector (3) to disconnect it from the SCCM.
5. Disconnect the instrument panel wiring harness from the back of the left multi-function switch.
6. Remove the switch (2) from the SCCM (1).
INSTALLATION
1. Position the left multi-function switch in the slot in the back of the Steering Column Control Module (SCCM) (1) and connect the switch connector (3).
2. Connect the instrument panel wiring harness connector to the back of the left multi-function switch.
3. Align switch with the SCCM (2) and slide toward steering column.
4. Install the screw (2) that secures the switch (3) to the SCCM (1).
5. Install the upper and lower shrouds onto the steering column.
6. Connect the battery negative cable.