B1934

B1934-DRIVER (LEFT) DOOR LOCK/UNLOCK SWITCH CIRCUIT STUCK - CLUSTER

B1934 - Driver (Left) Door Lock/Unlock Switch Circuit Stuck - Cluster:

WHEN MONITORED
Continuously

SET CONDITION
When the Left Door Lock Switch MUX circuit is between 0.8 and 1.5 volts for over 10 seconds.

POSSIBLE CAUSES
- (P697) Left door lock switch MUX circuit partial short to ground
- Door lock switch short to ground
- Instrument cluster

Theory of Operation
For a Right Hand Drive (RHD) vehicle, this DTC will refer to the Left Door.

Diagnostic Test

1. TEST FOR INTERMITTENT CONDITION

With the scan tool, record and erase DTC's
Operate the Left Door Lock Switch in all positions several times.
Cycle the ignition from on to off.
Turn the ignition on.
With the scan tool, read DTC's.

Q: Does the scan tool display B1934-DRIVER DOOR LOCK/UNLOCK SWITCH CIRCUIT STUCK?

YES: Go To 2
NO: The conditions that caused this code to set are not present at this time. Using the wiring diagram/schematic as a guide, inspect the wiring and connectors. Perform the BODY VERIFICATION TEST - VER 1. Body Verification Test




2. DOOR LOCK SWITCH SHORTED

With the scan tool, erase DTC's.
Disconnect the Left Door Lock Switch connector.
With the scan tool, read DTC's.

Q: Does the scan tool display B1934-DRIVER DOOR LOCK/UNLOCK SWITCH CIRCUIT STUCK?

NO: Replace the Left Door Lock Switch. Perform the BODY VERIFICATION TEST - VER 1. Body Verification Test
YES: Go To 3




3. (P697) LEFT DOOR LOCK SWITCH MUX CIRCUIT PARTIAL SHORT TO GROUND

Turn the ignition off.
Disconnect the Cluster C2 connector.
Measure the resistance between ground and the (P697) Left Door Lock Switch MUX circuit.

Q: Is the resistance below 10,000.0 ohms?

YES: Repair the (P697) Left Door Lock Switch MUX circuit for a short to ground. Perform the BODY VERIFICATION TEST - VER 1. Body Verification Test
NO: Replace the Instrument Cluster. Perform the BODY VERIFICATION TEST - VER 1. Body Verification Test