Radio/Stereo: Service and Repair

RADIO

REMOVAL




1. Disconnect and isolate the battery negative cable.
2. Remove instrument panel center bezel.
3. Remove mounting fasteners and remove radio from instrument panel.
4. Disconnect wire harness connector from radio.

CAUTION: Pulling the antenna cable straight out of the radio without pulling on the locking antenna connector could damage the cable or radio.




5. Disconnect the antenna cable (3) by pulling the locking antenna connector (2) away from the radio (1).

INSTALLATION




1. Connect the wire harness connector and antenna cable to radio.
2. Insert radio into instrument panel.
3. Install mounting fasteners. Tighten to 2 N.m (20 in. lbs.).
4. Install instrument panel center bezel.
5. Connect battery negative cable.