Idle Speed/Throttle Actuator - Electronic: Service and Repair

REMOVAL




When servicing throttle body components, always reassemble components with new O-rings and seals where applicable. Never use lubricants on O-rings or seals, damage may result. If assembly of component is difficult, use water to aid assembly.
1. Disconnect negative cable from battery.
2. Remove electrical connector from idle air control motor.
3. Remove idle air control motor mounting screws.




4. Remove motor from throttle body. Ensure the O-rings is removed with the motor.

INSTALLATION




When servicing throttle body components, always reassemble components with new O-rings and seals where applicable. Never use lubricants on O-rings or seals, damage may result. If assembly of component is difficult, a light coat of engine oil may be applied to the O-RINGS ONLY to aid assembly.
1. The new idle air control motor has a new O-ring installed on it.




2. Carefully place idle air control motor into throttle body.
3. Install mounting screw. Tighten screw to 7 N.m (62 in. lbs.) torque.
4. Connect electrical connector to idle air control motor.
5. Connect negative cable to battery.