Antenna Body and Cable

ANTENNA BODY AND CABLE

REMOVAL




1. Disconnect and isolate the battery negative cable.
2. Remove antenna mast by unscrewing mast from antenna body. On vehicles equipped with manual retractable antenna, lower antenna fully.
3. Remove shroud (1), if equipped.
4. Remove antenna nut (2) and adapter (3)




5. Disconnect antenna body cable from instrument panel antenna cable.
6. Remove inner fender shield as necessary to gain access to mounting fasteners.
7. Remove antenna body and cable (2) assembly from fender (1)

INSTALLATION




1. Position antenna body and cable assembly (2) into fender (1).
2. Insert antenna cable through the opening in fender.




3. Seat the grommet in the side panel and connect the cable to the instrument panel harness connector.
4. Install antenna nut (2) and adapter (3).
5. Install shroud (1), if equipped.
6. Install the inner fender shield.
7. Install antenna mast. Tighten to 5 N.m (46 in. lbs.). Ensure that the antenna mast is fully seated on antenna base and that there is no gap between the mast and base.
8. Connect the antenna cable to the instrument panel antenna cable.
9. Install the right side cowl trim panel.
10. Connect the battery negative cable.