Cruise Control Switch: Service and Repair

SWITCH
The speed control switches is mounted in the steering wheel and wired through the clock spring device under the airbag module.

WARNING: IF REMOVAL OF AIRBAG MODULE IS NECESSARY, REFER TO THE RESTRAINT SYSTEMS.

REMOVAL







1. Remove the air cleaner lid, disconnect the inlet air temperature sensor and makeup air hose.
2. Remove the negative battery cable.
3. Turn off ignition.
4. Remove air bag, refer to the Restraint systems.
5. Remove the top mounting screw.




6. Rotate steering wheel so that the switch is in the 6 o'clock position. Remove 2 screws from the back side of the speed control switch.
7. Disconnect the electrical connector.
8. Remove switch.

INSTALLATION







1. Connect the electrical connector.




2. Install switch and tighten the screws (1) to 1.6 N.m (15 in. lbs.). Make sure rubber seal is in place around switch.
3. Install airbag, refer to the Restraint Systems.
4. Install the negative battery cable.
5. Install the air cleaner lid, connect the inlet air temperature sensor and makeup air hose.