Rear Door Window Regulator

REAR DOOR WINDOW REGULATOR

REMOVAL
1. Remove door trim panel and watershield.
2. Remove door glass from regulator channel. Secure glass in the door frame in the "UP" position.
3. Remove fasteners attaching window regulator channel and crank motor to door panel.
4. Disengage wiring at clip.
5. Disengage regulator from door panel, and motor housing.
6. Slide regulator rearward and rotate forward end of channel through access hole in door panel.
7. Remove window regulator from door through access hole in inner panel.

INSTALLATION
1. Position window regulator and motor housing on door panel through access hole in door panel.
2. Install fasteners attaching window regulator to door panel.
3. Position glass to regulator roller channel.
4. Tighten fasteners attaching door glass to lift plate.
5. Engage electrical wiring.
6. Position watershield, and install door trim panel.