Drink Holders: Service and Repair

REMOVAL
1. Remove the screw access cover from the bottom of the center bezel.
2. Remove the center bezel attaching screws.
3. Using a trim stick (special tool # C-4755) or equivalent, gently pry out on the edge of the instrument panel center bezel. Hang off to the side leaving the accessory switches connected.

Tray Cup Holder:

4. Pull the cup holder assembly rearward to disengage the rear guide studs from instrument panel.
5. Remove the cup holder assembly from lower instrument panel.

INSTALLATION
1. Ensure the cup holder assembly is in the closed position. The cup holder assembly must be installed as an assembly to ensure proper track position.
2. Place the cup holder assembly into position in the lower instrument panel and slide into opening until the rear guide struts snap into place.
3. Install the center bezel.
4. Install the center bezel attaching screws.
5. Install the screw access cover to the bottom of the center bezel.