Front Control Module (FCM)

REMOVAL
1. Disconnect and isolate the negative and positive battery cables from the battery.
2. Remove the battery.

Removing Integrated Power Module:

3. Using a long flat-bladed screwdriver, gently twist the Integrated Power Module (IPM) retaining clip outboard to free the IPM from its mounting bracket. Rotate IPM upward to access the Front Control Module (FCM) retaining screws.
4. Remove the front control module retaining screws.

Front Control Module:

5. Pull the FCM straight from the PDC assembly to disconnect the electrical connector and remove the FCM from the vehicle.

INSTALLATION

NOTE: Front Control Module must be programmed to the correct radio EQ curve using the DRBIII(R). This will ensure that the audio system is operating correctly.

1. Install the Front Control Module (FCM) in the Power Distribution Center (PDC) assembly by pushing the 49-way electrical connector straight in.
2. Install the FCM retaining screws. Torque the screws to 1 N.m (7 in. lbs).
3. Rotate the IPM assembly downward to secure in mounting bracket.
4. Install the battery in the vehicle. Refer to the procedure in Battery.
5. Connect the positive and negative battery cables.
6. Using the DRBIII(R), under "FRONT CONTROL MODULE" then "MISC" program the EQ curve of the radio into the Front Control Module.

NOTE: If the vehicle is not equipped with Name Brand Speakers (Infinity, etc.) or Headlamp Washers the DRBIII(R) must be used to Disable the appropriate relays in the Integrated Power Module Assembly.