Sliding Door Opening Mounted

REMOVAL
The right and left second row side impact sensors, are mounted identically, on opposite sides of the vehicle, in the sliding door opening lower rear where the lower roller arm mounts in the lower door track.

1. Open hood, disconnect and isolate the battery negative cable.

WARNING: WAIT TWO MINUTES FOR THE SYSTEM RESERVE CAPACITOR TO DISCHARGE BEFORE BEGINNING ANY AIRBAG COMPONENT SERVICE. PERSONAL INJURY OR DEATH MAY RESULT.

2. Open sliding door to the fullest open position.

2nd Row Side Impact Sensor:

3. Remove the two retaining screws to the impact sensor.
4. Disconnect the electrical connector from the impact sensor and remove from vehicle.

INSTALLATION
1. Connect electrical connector.
2. Position sensor in vehicle.
3. Install the two retaining screws to the impact sensor. Torque screws to 7 N.m (62 in. lbs.).

WARNING: DO NOT CONNECT THE BATTERY NEGATIVE CABLE. PERSONAL INJURY OR DEATH MAY RESULT IF THE SYSTEM TEST IS NOT PERFORMED FIRST.

4. Verify vehicle and system operation.
5. Close hood.