Installation

INSTALLATION





NOTE: The adjustable brake pedal is serviced as a complete assembly including accelerator pedal and the bracket.

NOTE: The adjustable brake pedal is serviced as a complete assembly including the adjustable pedal motor, cable and the bracket.

1. Install the pedal assembly (2) to the vehicle.
2. Install the mounting bolts (1) and tighten to 8 Nm (75 in. lbs.).
3. Push the booster back into the cowl.
4. Install the two bolts to the electrical bulkhead to the pedal bracket.
5. Reconnect the adjustable pedal assembly electrical connectors.Adjustable pedals only.




6. Install the booster mounting nuts (1) Tighten to 28 Nm (250 in. lbs.).




7. Reconnect the new booster push rod clip (1) and install the rod (2) to the pedal (3).




8. Install the steering column (2) to the vehicle..
9. Raise the column (2) upwards on the mounting studs and then install the mounting nuts (1). Tighten to 28 Nm (250 in. lbs.).
10. Install a new brake lamp switch .




11. Install the upper coupling to the steering column (1) then install the pinch bolt to the upper coupling (2). Tighten to 38 Nm (28 ft. lbs.).
12. Install the steering column opening cover.
13. Install the steering column opening cover reinforcement.
14. Install the upper and lower shrouds.
15. Reconnect the negative battery cable.