Trunk / Liftgate Interior Trim Panel: Service and Repair

PANEL-TRIM

REMOVAL




1. Using a trim stick C-4829-A or equivalent, separate the pushpin fasteners and remove the upper trim panel (2).




2. Remove the two upper screws (3) and the four lower screws (5).
3. Remove the lower trim panel (4) and disconnect the electrical connector.

INSTALLATION




1. Connect the electrical connector and install the lower trim panel (4) onto the guide pins (2).
2. Install the four lower screws (5) and two upper screws (3).




3. Position the upper trim (2) into place and seat the push pin fasteners fully.