Removal

REMOVAL





NOTE: The front wiper motor can be removed from the wiper module without removing the module from the vehicle, and is available as a separate service component for this vehicle.

1. Disconnect and isolate the battery negative cable.

2. Remove both front wiper arms from the wiper pivots.

3. Remove the cowl plenum cover/grille panel from over the front wiper module.

4. Disconnect the wire harness connector (5) from the front wiper motor connector.

5. Remove the screw (3) that secures the front wiper module bracket (6) and the center bracket of the cowl grille support (7) to the cowl plenum panel (1).

6. Remove the three screws (2) that secure the module bracket to the cowl plenum panel and the left front fender ledge.

7. Remove the wiper module from the engine compartment as a unit.