Seat - Installation

INSTALLATION




1. Before proceeding with the following repair procedure, review all warnings and cautions.

WARNING: The Seat Weight Sensor is a sensitive, calibrated unit and must be handled carefully. Do not drop or handle roughly. If dropped or damaged, replace with another sensor. Failure to follow these instructions may result in personal injury or death.


WARNING: The front passenger seat must be handled carefully as well. When removing the seat, be careful when setting on floor not to drop. If dropped, the sensor may be inoperative. Failure to follow these instructions may result in personal injury or death.


WARNING: When the seat is on the floor, no one should sit in the front passenger seat. This uneven force may damage the sensing ability of the seat weight sensors. If sat on and damaged, the sensor may be inoperative. Failure to follow these instructions may result in personal injury or death.

2. Position the seat into the vehicle and connect the electrical connectors (3), if equipped.

3. Install the two front bolts (4) and three rear bolts (2).

4. Tighten the front inner bolt to 27 Nm (20 ft. lbs.) then tighten the front outer bolt to 27 Nm (20 ft. lbs.).

5. Tighten the rear bolts to 47 Nm (35 ft. lbs.).

6. Install the lower seat belt anchor (1) and install the bolt.

7. Tighten the bolt to 39 Nm (29 ft. lbs.) and install the trim cover (1).

8. Do not reconnect the battery negative cable at this time. The supplemental restraint system verification test procedure should be performed following service of any supplemental restraint system component.

9. Following successful completion of the supplemental restraint system verification test procedure, perform the Occupant Classification System Verification Test using a scan tool.