Installation

INSTALLATION




1. Verify that U-nuts (1) are in position in the roof bow #2 (2).

2. Verify that glass panel is loose and slightly retracted.




3. Raise sunroof module assembly (4) and guide it carefully into position.

4. While supporting the sunroof assembly, start the 12 attaching screws, three along each side rail, two along the front trough and four along the motor bracket.

5. Locate the alignment holes along the sides of the module assembly and position the holes so that they line up with the holes located in the roof top support brackets.




6. Tighten the attaching screws to 6 Nm (53 in. lbs.) using the sequence shown.




7. Connect the electrical connector (4).




8. Connect the drain tubes to the sunroof (1).




9. Position the video display support bracket (2), if equipped, and install the bolts (1 & 4). Tighten the bolts to 6 Nm (53 in. lbs.).

10. Connect battery negative cable.

11. Test sunroof operation, adjust if necessary.

12. Install headliner.