Installation

INSTALLATION

Power




1. Before proceeding with the following repair procedure, review all warnings and cautions.

WARNING: A seat structure that has seen significant load may have the locking mechanism activated and may exhibit the following symptoms:
- Locking pawl (2) loose
- Locking pawl (2) engaged into the seat frame sidemember (1)
- Height adjuster only works on outboard side
- Broken or missing shear pin (3)


If any one or more of these symptoms exist replace the height adjuster assembly. Do not attempt any repairs. Failure to follow these instructions may result in personal injury or death.




2. Install the seat risers.

3. Position the height adjuster assembly (1) onto the length adjuster assembly (3) and install the nuts, bolts and spacers on the inboard side.

NOTE: Bolts (2) and (4) are different and need to be installed into the correct positions.

4. Tighten the bolts to 21 Nm (15 ft. lbs.).

5. Install the seat cushion and install the seat.

Manual




1. Install the seat risers.

2. Position the side member assembly (3) onto the length adjuster assembly (5) and install the nuts (6), bolts (1 & 4) and spacers (2) on the inboard side.

3. Tighten the bolts to 42 Nm (31 ft. lbs.).




4. Squeeze the towel bar together and insert the ends into the bushings on both tracks.




5. Install the spring clip.

6. Install the seat cushion and install the seat.