Front

FRONT

WARNING: To avoid serious or fatal injury on vehicles equipped with airbags, disable the supplemental restraint system before attempting any steering wheel, steering column, airbag, seat belt tensioner, impact sensor, or instrument panel component diagnosis or service. Disconnect and isolate the battery negative (ground) cable, then wait two minutes for the system capacitor to discharge before performing further diagnosis or service. This is the only sure way to disable the supplemental restraint system. Failure to take the proper precautions could result in accidental airbag deployment.

WARNING: To avoid serious or fatal injury, never strike or drop the front impact sensor, as it can damage the impact sensor or affect its calibration. The front impact sensor enables the system to deploy the front supplemental restraints. If an impact sensor is accidentally dropped during service, the sensor must be scrapped and replaced with a new unit. Failure to observe this warning could result in accidental, incomplete, or improper front supplemental restraint deployment.





1. Position the right or left front impact sensor (1) into the engine compartment.

2. Reconnect the headlamp and dash wire harness connector (4) to the sensor connector receptacle.

3. Position the sensor onto the back of the right or left radiator support vertical member (2). Be certain that the anti-rotation pin on the back of the sensor is engaged in the lower clearance hole of the radiator support.

4. Install and tighten the screw (3) that secures the sensor to the back of the support vertical member. Tighten the screw to 6 Nm (55 in. lbs.).

5. Do not reconnect the battery negative cable at this time. The supplemental restraint system verification test procedure should be performed following service of any supplemental restraint system component.