Installation

INSTALLATION





If reinstalling the airbag cover onto the same passenger airbag, perform the following adjustment. Otherwise, go to STEP 1.

- Using a 90° needle nose pliers or equivalent, place the pliers on the rear edge of the airbag cover metal flap retainer.
- Bend roughly 10° so that the metal flap is closed slightly to eliminate rattles of the airbag cover.
- Bend until the measurement of the metal flap to airbag housing is 7 - 8.3 mm (use a drill bit ranging from 9/32 - 21/64 inch).
1. Snap cover onto the passenger airbag frame.

2. Install the passenger airbag.

WARNING: DO NOT CONNECT THE BATTERY NEGATIVE CABLE. PERSONAL INJURY OR DEATH MAY RESULT IF THE SYSTEM TEST IS NOT PERFORMED FIRST. FOR THE SYSTEM TEST, Supplemental Restraints Verification Test